RESUMELOG

RESUMELOG

     Resumes system logging following suspension caused by an error.

SYNTAX

     RESUMELOG

PARAMETERS

     None.

OPERATION

     When the operator directs MPE/iX to resume logging with
     RESUMELOG, a special Log Record is displayed that denotes
     the number of log events and corresponding records that were
     not recorded while logging was suspended; the total number
     of unrecorded job initiation records; and the total number
     of unrecorded job/session termination records.

     This command may be issued from a session, job, program, or
     in BREAK.  It may be executed only from the console (unless it
     is distributed to users with the ALLOW command), or by a
     user with system supervisor (OP) capability.

EXAMPLE(S)

     Assume the system is online and running with logging
     enabled.  If a recoverable error occurs, the following error
     message is sent to the system console

     ST/1043/LOG FILE NUMBER 104 ERROR #46.  LOGGING SUSPENDED.

     After the error is corrected, enter RESUMELOG.  A
     confirmation message will then appear at the system console,
     as follows

     ST/1045/LOGFILE NUMBER 104. LOGGING RESUMED.
     ST/1045/LOG FILE NUMBER 104 ON.

ADDITIONAL INFORMATION

Commands:

Manuals :   Performing System Operation Tasks (32650-90137)

            System Startup, Configuration, and Shutdown Reference
            Manual (32650-90042)